By The Sea

Need complete design for Reaper Drone in solid Works for each part of the stucture (Fuselage+ wings+ wheels) no need for engine and inside equipements, and i don't need rocket design and no need also for 2D drafting

Hi Cad Crowd! We're in need of adjusting one of the components of our product. We have an existing 3D model that we need adjusted. We are keeping the same top and bottom connection the same. The basic design is similar to a standard universal phone mount for a car. We want to use the same mechanism as shown in the pictures and then adjust it to our requirements. The system will be 3 major components. Part 1: Back piece that has top connection and bottom connection which won't be changed much except for the width. This area will be where the gears/spring/everything sits on. Part 2: This will be the two "wing walls" that extrude left and right that will be sat on the back plate area. Part 3: Will enclose this area and have a bottom stub where the phones sit. We play on adding some little foam on the front of part 3 and on the insides of the wing walls. We think that the gear mechanism can be reduced in size and that we can flip it so that they sit above the wing walls (and in the center of the system).

寻找某人图纸转化为3 dmodels. Product is a personal drone that emits light, launched from a cylindrical housing unit.

Smart PGS is a system that a device that is hanging off a rail under parking lot ceiling to monitor parking spaces using camera. It monitors 6 - 12 spaces (3 - 4 per side), hence two cameras. And it shows vacancy (Green) or full (Red) or special condition ( Blue ) to guide driver for a parking spot.

It is based on the contest we posted last time. //www.johnregoli.com/contest/2655-breakaway-and-adjustable-collar-for-cats We need 3-5 aesthetics concepts based on the CAD we uploaded, maybe it can be ribbon, fish... as long as it is cat-related. Also, please minimize the level of adjustment into 3. The numeric level needed to be engraved on the wheel clearly, font can be any as long as it looks nice. The overall size of the buckle needs to be smaller, at least the same size or smaller than 22mm x 16mm. We want to make the wheel turning the switch from back to the front, like in the attached picture. But the arrow needed to be smaller. The whole CAD needs to be ready for mass production as we will open the aluminum mold for it.